在使用vmare workstation或者vsphere的环境下安装centos7的时候，会把网卡名称默认调整为ens167，满足一致性命名，而非eth0等。有时候需要修改网卡名称，满足一般配置运维寻求
CentOS7修改网卡为eth0
.编辑网卡信息
# cd /etc/sysconfig/network-scripts/ #进入网卡目录
# mv ifcfg-eno16777728 ifcfg-eth0 #重命名网卡名称
# cat ifcfg-eth0 #编辑网卡信息
TYPE=Ethernet
BOOTPROTO=static
DEFROUTE=yes
PEERDNS=yes
PEERROUTES=yes
IPV4_FAILURE_FATAL=no
NAME=eth0 #name修改为eth0
ONBOOT=yes
IPADDR=192.168.56.12
NETMASK=255.255.255.0
GATEWAY=192.168.56.2
DNS1=192.168.56.2修改grub
[[email protected]~]# cat /etc/sysconfig/grub #编辑内核信息,添加红色字段的
GRUB_TIMEOUT=5
GRUB_DEFAULT=saved
GRUB_DISABLE_SUBMENU=true
GRUB_TERMINAL_OUTPUT="console"
GRUB_CMDLINE_LINUX="crashkernel=autorhgb net.ifnames=0 biosdevname=0 quiet"
GRUB_DISABLE_RECOVERY="true"
[[email protected]~]# grub2-mkconfig -o /boot/grub2/grub.cfg #生成启动菜单
Generatinggrub configuration file ...
Foundlinux image: /boot/vmlinuz-3.10.0-229.el7.x86_64
Foundinitrd image: /boot/initramfs-3.10.0-229.el7.x86_64.img
Foundlinux image: /boot/vmlinuz-0-rescue-1100f7e6c97d4afaad2e396403ba7f61
Foundinitrd image: /boot/initramfs-0-rescue-1100f7e6c97d4afaad2e396403ba7f61.img
Done验证是否生效
[[email protected]~]# reboot #必须重启系统生效
[[email protected]~]# yum install net-tools #默认centos7不支持ifconfig 需要看装net-tools包
[[email protected]~]# ifconfig eth0 #在次查看网卡信息
eth0:flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.56.12 netmask 255.255.255.0 broadcast 192.168.56.255
inet6 fe80::20c:29ff:fe5c:7bb1 prefixlen 64 scopeid 0x20<link>
ether 00:0c:29:5c:7b:b1 txqueuelen 1000 (Ethernet)
RX packets 152 bytes 14503 (14.1 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 98 bytes 14402 (14.0 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0原文地址：http://blog.51cto.com/11555417/2134746
时间： 2024-10-09 16:46:57